Manometers MP KIMO MP -K: from to °C -J: from to °C -T: from to °C CO/Temperature: CO: from 0 to ppm, from Consult KIMO’s MP brochure on DirectIndustry. Page: 1/4. This is the MP Thermo-Anemo-Manometer. It is an easy to use meter which can take complex measurements. The MP is designed to measure Air.
|Published (Last):||16 May 2004|
|PDF File Size:||6.24 Mb|
|ePub File Size:||2.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
On enabled mode, the probe m connected, the measurement is carried out and the value is displayed. From this screen you can: Enter dataset time and interval of time between 2 measurements by selecting Period with access key.
If the probe is connected for more than 1 minute, measurement screen appears and indicates the concentration and places it on a bargraph. Alarm threshold corresponds to the right value on the bargraph. For measurement launching, click on OK with the access key. This datasets can’t be set using Datalogger Software.
If Other is selected, you must enter a value. Once pressing Autoz key, the zero is readjusted. Press 1x in order to select HOLD function: With Pressure function, you can access to following sub-functions – Hold – see Air velocity – Config. Press 2x in order to select Min-Max function: Select Start with access key for launching measurement.
It is mo necessary to enter the real temperature of use to obtain more precise results. From this screen, you can: On disabled mode, the probe is connected, the measurement is mmp carried out and the value is not displayed. Several actions are possible during the measurement: When kumo measurement is fixed, press Min Max to access to maximum and minimum values of the measurement. When CO peak is selected, the period is diplayed 30 seconds by default. Click on OK to validate.
Kimo MP 200 H Thermo Anemometer Manometer Air Velocity Pressure Sensor
The number of points selected and the parameter are displayed. Click on Mesure to display values table of selected dataset.
Preview of tables of points of datasets Dataset summary You can display tables of points of datasets performed on kumo device. Configuration – Params Parameters – Avg.
Kimo MP200 Thermo-Anemo-Manometer
If K factor is selected, you must enter value. Summary screen of selected dataset is displayed. Probe Hold Alarms Params Veloci.
If you want to see all values, select Visu.
Kimo MP HP Thermo Anemometer Manometer Air Velocity Meter
For each location, 2200 operator can enter a theorical value and a tolerance for the parameter to be controlled. From this screen, press Measure to back to measurement. If you click on average icon, max. Planification must be made via the software.
The oimo of points is displayed. If the probe has been just connected, the screen indicates the remaining time of warm up then the measurement screen appears, indicates the concentration and places it on a bargraph. Use the arrows to modifiy the threshold value then press Validate to validate alarm threshold and back to measurement screen.